Micro Engineering Solutions

Micro Engineering Solutions, Inc.[1] was a CAD/CAM (Computer Aided Design / Computer Aided Manufacturing) software company founded in 1986 by Lynn and Jim Hock and Bill Harris in Farmington, Michigan. The initial product was "Solution 3000", a PC-based CAD/CAM system that ran on a standard IBM PC AT (or clone), running under IBM PC DOS, with 640 KB of memory. Additional required hardware included a math coprocessor, a 20 MB hard disk drive with floppy disk backup, a graphics display interface, and a graphics monitor.

Solution 3000 featured true full 3D modeling capability, including both design and manufacturing capabilities. Optional packages included:

Advanced Surfacing / NC Machining Advanced Conversion Programs: IGES (Initial Graphics Exchange Specification), DXF (AutoCAD Format),[2] DES (General Motors), Ford Standard Tape, and Chrysler's format.

In 1990, Micro Engineering Solutions, Inc. was purchased by a group of investors that included Morganthaler Ventures, 3I Ventures, and GeoCapital.[3]

In 1991, the Board appointed Ken Spenser as president and CEO.[4]

On October 19, 1992, Autodesk Inc, Sausalito CA acquired Micro Engineering Solutions.[5]

References

  1. ^ "MICRO ENGINEERING SOLUTIONS - Reviews & Brand Information - MICRO ENGINEERING SOLUTIONS FARMINGTON HILLS, MI - Serial Number: 73671015". Trademarkia.com. Retrieved 2015-05-14.
  2. ^ "What is DXF? What Opens a DXF? File Format List from WhatIs.com". Whatis.techtarget.com. Retrieved 2015-05-14.
  3. ^ "MICRO ENGINEERING SOLUTIONS, INC. - MichiganCorporates – Company Profiles of Michigan". Michigancorporates.com. Retrieved 2015-05-14.
  4. ^ "Businessman, Entrepreneur, Navy Captain, Personal Trainer and Consultant - Ann Arbor, MI". Kennethspenser.com. Retrieved 2015-05-14.
  5. ^ "Micro Engineering Solutions Acquisition". Fourmilab.ch. 1992-10-16. Retrieved 2015-05-14.

Content Disclaimer

Informasi ini disarikan dari Wikipedia dan disajikan kembali untuk tujuan edukasi. Konten tersedia di bawah lisensi CC BY-SA 3.0. Kami tidak bertanggung jawab atas ketidakakuratan data yang bersumber dari kontribusi publik tersebut.

  1. The information displayed on this website is sourced in part or in whole from Wikipedia and has been adapted for the purpose of restating it. We strive to provide accurate and relevant information, however:
  2. There is no guarantee of absolute accuracy. Wikipedia is an open, collaborative project that can be edited by anyone, so information is subject to change.
  3. It is not intended to constitute professional advice. The content displayed is for informational and educational purposes only. For important decisions (e.g., medical, legal, or financial), please consult a professional.
  4. Content copyright. Wikipedia is licensed under the Creative Commons Attribution-ShareAlike License (CC BY-SA). This means that content may be reused with appropriate attribution and shared under a similar license.
  5. Responsible use. Any risk arising from the use of information from this website is entirely the responsibility of the user.