Manumatic

The modern usage of the automotive term manumatic denotes an automatic transmission that allows the driver to select a specific gear, typically using paddle-shifters, steering wheel-mounted push-buttons, or "+" and "-" controls on the gear selector.[1]

In the 1950s, the Automotive Products company in the United Kingdom produced an automated clutch system for automobiles called the Manumatic. This system was installed in cars with a manual transmission, allowing them to be driven without needing to use a clutch pedal.

Automatic transmissions

Since the popularization of the hydraulic automatic transmission in the 1940s, many automatic transmissions have allowed indirect control of the gear selection, usually in the form of locking out higher gears. This was provided to allow engine braking on downhills or prevent the use of overdrive gears when towing and was typically achieved using positions such as "3", "2", and "1" on the gear selector.

An automatic transmission with a manumatic function provides a greater level of control by allowing the driver to request an upshift or downshift at a specific time. This is usually achieved using "+" and "-" positions on the gear selector or with paddle-shifters mounted beside the steering wheel. On modern gear selectors with "+" and "-" positions, the positions are on a connected longitudinal gate to the left or right of the standard gear positions. Several Chrysler and Mercedes-Benz vehicles from the 2000s have horizontal gates at the bottom of the shifter pattern. Manufacturers use a variety of tradenames for the manumatic function, as listed below.

The driver often does not have full control of the gear selection, as most manumatic modes will deny a gear change request that would result in the engine stalling (from too few RPM) or over-revving. Some transmissions will hold the requested gear indefinitely, while others will return to automatic gear selection after a period of time.

Tradenames

1950s automated clutch system

Main article: Automotive Products

The Automotive Products company in the United Kingdom produced an automated clutch system for automobiles in the 1950s called the Manumatic. This system is largely unrelated to later use of the term relating to automatic transmissions. The Manumatic was installed in cars with a manual transmission, allowing them to be driven without needing to use a clutch pedal.[2] According to the modern use of the term it would be classified as an automated manual transmission and not as a manumatic transmission.

See also

References

  1. ^ "MANUMATIC English Definition and Meaning". Lexico.com. Archived from the original on November 4, 2021. Retrieved 2022-08-24.
  2. ^ Abbey, Staton. "Practical Automobile Engineering - Clutch Systems": 193–194. {{cite journal}}: Cite journal requires |journal= (help)

Content Disclaimer

Informasi ini disarikan dari Wikipedia dan disajikan kembali untuk tujuan edukasi. Konten tersedia di bawah lisensi CC BY-SA 3.0. Kami tidak bertanggung jawab atas ketidakakuratan data yang bersumber dari kontribusi publik tersebut.

  1. The information displayed on this website is sourced in part or in whole from Wikipedia and has been adapted for the purpose of restating it. We strive to provide accurate and relevant information, however:
  2. There is no guarantee of absolute accuracy. Wikipedia is an open, collaborative project that can be edited by anyone, so information is subject to change.
  3. It is not intended to constitute professional advice. The content displayed is for informational and educational purposes only. For important decisions (e.g., medical, legal, or financial), please consult a professional.
  4. Content copyright. Wikipedia is licensed under the Creative Commons Attribution-ShareAlike License (CC BY-SA). This means that content may be reused with appropriate attribution and shared under a similar license.
  5. Responsible use. Any risk arising from the use of information from this website is entirely the responsibility of the user.